[chbot] Raspberry Pi etc.

[Henri Shustak]

Hi,

Be keen to know how you get on with all this. Keep in touch.

Henri 

> On 17/08/2021, at 7:29 PM, Starr Moffatt <zl3custarr at gmail.com> wrote:
> 
> Hi All,
> 
> Thank you for including me as a member.
> 
> I was the person that asked for help regards using the Raspberry Pi for logging electrical data.
> 
> As I thought I might be chatting only to a few people, rather than the whole group, I did not have anything prepared.
> 
> Thank you for the suggestions. As mentioned it was too much for me to remember everything so please also inform me using this list. (Or use my email address  zl3custarr at gmail.com )
> 
> Please see below more info.
> 
> USING A RASPBERRY PI FOR LOGGING ELECTRICAL QUANTITIES
> 17 AUGUST 2012
> 
> The idea for this came about at my brothers place where it was thought that maybe due to an “unseen” water leak the water pump would be operating at “regular” intervals and therefore consuming electricity.
> 
> For this to be checked the best place to monitor the pump circuit is at the switchboard.
> 
> A clip on a.c. current sensor would be the best option for detecting when the pump was operating.
> 
> For this to be logged, the current sensor could drive a 4N26 opto isolator along with a storage capacitor arrangement on its output, to provide a constant signal to the Raspberry Pi’s input while the current was flowing to the pump. Note this would not provide a value of current, instead just the indication that the pump was on or off.
> 
> The Pi would be required to log this on/off state, at regular intervals, say 1 minute, along with a time/date stamp. Therefore the Pi would need to populate a suitable spread sheet with this data.
> Mark, I think you had some suggestions on this so I would appreciate you written comments.
> 
> Peter Harris suggested I look at Openenergy Monitor which I have done and I have found a suitable circuit for the current sensor arrangement. Thank you.
> 
> Another idea that I am looking at is to be able to check the times that a water heating circuit is enabled. This would only need a 230V coil relay with a NO contact connected between a Pi supply and one of its inputs. This would also require another column to be populated in the spread sheet.
> 
> In the future:
> I am also thinking that it may be of use to record the values of current and voltage. Again a spreadsheet would be needed which could also have columns for power and, using integration, kWh. I guess an Arduino would be simpler as it has built in A to D conversion, however as I already have the Pi I will persevere with it at this stage. Just looking at the drawing for the current sensor for the Arduino; https://learn.openenergymonitor.org/electricity-monitoring/ct-sensors/files/Arduino_AC_current_input_A.png 
> it looks as if the software determines the peak value and from there calculate the RMS value. I assume the voltage RMS value will also be calculated using the peak value as well. I have heard that the scan rate of the Pi is slower than the Arduino so I wonder if this would have a bearing  on the Pi’s ability to determine the peak value.
> 
> 
> 
> Cheers,
> 
> Starr Moffatt
> 
> 
> _______________________________________________
> Chchrobotics mailing list Chchrobotics at lists.ourshack.com
> https://lists.ourshack.com/mailman/listinfo/chchrobotics
> Mail Archives: http://lists.ourshack.com/pipermail/chchrobotics/
> Meetings usually 3rd Monday each month. See http://kiwibots.org for venue, directions and dates.
> When replying, please edit your Subject line to reflect new subjects.