[chbot] Low power PC/Device for linux..

Richard Jones rjtp at ihug.co.nz
Mon Nov 5 00:30:04 GMT 2007

The atmel atngw100 does not quite meet your spec, but runs linux, costs 
about $125NZ from John McLean at Avnet in Sheffield Crescent,Chch. You 
can use the SD flash card interface for storage. See:



Richard Jones

Chris Hellyar wrote:
> Hi-ho,
> I'm looking for a local supplier of a PC/device suitable for use as an
> industrial data logger/controller.
> Needs to run from 12V supply (14.1V-11.5V) run a full linux ditro (etch
> probably) have a real hard disk drive interface (for laptop/SSD ATA/SATA
> drive), a couple of serial ports and an ethernet interface.  Not worried
> about speed too much, and need to keep the power down around 10W.
> Anyone used anything like this, or got a weblink they want to share for a
> local option?  I've found a few overseas on the web, but would prefer a
> local supplier if possible.
> They are for use in a prototype wind turbine control / data logging /
> weather station setup.
> Cheers, Chris Hellyar
> p: 03 324 4462
> c: 027 255 3494
> w: http://cpix.co.nz
> _______________________________________________
> Chchrobotics mailing list
> Chchrobotics at lists.linuxnut.co.nz
> http://lists.ourshack.com/mailman/listinfo/chchrobotics

This email, including any attachments, is only for the intended
addressee.  It is subject to copyright, is confidential and may be
the subject of legal or other privilege, none of which is waived or
lost by reason of this transmission.
If the receiver is not the intended addressee, please accept our
apologies, notify us by return, delete all copies and perform no
other act on the email.
Unfortunately, we cannot warrant that the email has not been
 altered or corrupted during transmission.

More information about the Chchrobotics mailing list