[chbot] SMD components
markaren1 at xtra.co.nz
Sun Feb 18 07:00:02 GMT 2018
This is going to be a work in progress for a while.
Threw out the small stuff. The large stuff starts at 1.6 mm × 0.8 mm for
a resistor and capacitor - don't sneeze when you are laying out stock :)
On 18/02/2018 6:38 PM, Rory Deans wrote:
> I guess you should take a sample of each piece for the club stock. Not
> sure how you store them? Maybe club just keeps end of reel lines? Do I
> need to build some sort of rack system for the reels? Doubt whether
> Radiotek would use them in forseable future.
> I personally won't take any as can see the damn things!!
> -----Original Message----- From: Mark Atherton
> Sent: Sunday, February 18, 2018 5:55 PM
> To: Christchurch Robotics
> Cc: Rory Deans ; Ian MacPherson
> Subject: SMD components
> Our fine friends at Trimble have donated a whole pile of SMD stuff to
> the BR05 radio club, as well as to us at the Robotics Group.
> The main condition of the donation is that the plastic reels which the
> components are packaged on must not leave the BR05 club-room -- this is
> very important.
> In terms of actual components, they will be up for grabs at the Robotics
> meeting tomorrow (as well as the Tuesday evening BR05 meeting). Prices
> are 'reasonable donations' to our host club, via the brown-box.
> If this interests you, bring some plastic bags, pieces of paper to mark
> contents, and a pen.
> Component sizes are mainly 0603 and 0805 which can be handled reasonably
> Finally, please apply a little social conscience about how much you
> take; maybe limit purchases to 10% of each reel, or 300mm strip lengths,
> whichever is the smaller.
> A quick show of hands via this email service would be appreciated this
> evening just to gauge level of interest.
> See you Monday evening.
-------------- next part --------------
An HTML attachment was scrubbed...
More information about the Chchrobotics