[chbot] STC Microprocessor

[Mark Atherton]

Looks like this an 8051 core with their own peripherals attached - see 
http://clab.hyit.edu.cn/UploadFiles/20130818044624875.pdf page 1792

Also the part does not look very popular, so you may have a difficult 
time getting support.

never give up, never surrender (for 200 points, which movie ?)

-mark

On 7/09/2015 8:33 a.m., Marshland Engineering wrote:
> Hi Chaps
>
> I did post this before but I have not sorted out the problem as yet. I blew a
> few inputs on my welder's MCU and the replacement board I got was a later
> version so the welder does not work properly. I was wondering if I could read
> the original MCU program (if not locked) and reprogram the new board. The link
> for the processor  is
>
> http://www.stcmcu.com/
>
> They keep talking about a 8051 and my chip is STC12C5A60S2 but it is all in
> Chinese.  I've downloaded their ISP software but there does not appear to be a
> read option. Any help will be appreciated.
>
> Thanks Wallace
>
>
> _______________________________________________
> Chchrobotics mailing list Chchrobotics at lists.linuxnut.co.nz
> http://lists.ourshack.com/mailman/listinfo/chchrobotics
> Mail Archives: http://lists.ourshack.com/pipermail/chchrobotics/
> Meetings usually 3rd Monday each month. See http://kiwibots.org for venue, directions and dates.
> When replying, please edit your Subject line to reflect new subjects.
>