[chbot] Front panels (Re: 'Printing' an enclosure)

[Chris Hellyar]

Or Librecad…

Wont get into the politics, but this is one of those open office vs libreoffice things where a commercial firm supported an open source product but decided to monetise it a bit aggressively in the opinion of some of the community developers, so it was forked…

That was a while ago, one assumes they’ve sorted their differences out by now. :-)

(I use librecad, because it’s in the debian repo, but used to be a keen qcad user…)

On 21/09/2014, at 12:20 pm, Helmut Walle <helmut.walle at gmail.com> wrote:

> On 21/09/14 00:15, Richard Jones wrote:
>> An alternative method for making your front panel is to draw up what
>> you want in a drawing package (Eagle works for me).  Print the design
>> on paper and glue stick it on to your box. Then drill and cut out the
>> holes with needle files, abra file etc. Unwanted paper will wash off
>> under the tap. I find I can get accurate and repeatable results this
>> way. A bit low tech, but quick and cheap.
>> 
>> Richard
>> 
>> [...]
> 
> I highly recommend Qcad for this and other 2D drawing jobs that need to be completed to scale. You can then also include any labelling and scales for knobs etc. in the same drawing. Once printed, the paper can be laminated onto the actual front plate material by painting it with epoxy resin or a clear varnish. You can then still drill and cut your openings (carefully, so that the rest of the front plate printing isn't damaged). Alternatively, I have also made front panels from PCB material in the past - it has reasonable mechanical properties for that purpose, and often there is some of it floating around anyway. Or, if you are getting a whole PCB panel made anyway, and the actual electronic PCB is small, just use the rest of the PCB panel for the front panel.
> 
> I also remember making an entire enclosure from PCB material a long time ago - the front, top, bottom, left and right sides were all soldered together from the inside along the edges, and I then soldered some brass nuts into the back corners and along the edges to mount the back panel. This technique can also provide some RF shielding.
> 
> Kind regards,
> 
> Helmut.