[chbot] Stainless elbow

Robin Gilks robin at gilks.org
Tue Nov 27 01:24:33 GMT 2018

I'm currently 'rebuilding' the rocket mass heater with all the bodged bits
fixed up but I'm missing one part - a 90 (or two 45) degree bend(s) to
take the flue from under the floor to the chimney at the far end of the
tunnel house.

All the flue pipe I obtained is 150mm (6") light gauge stainless steel
push fit between lengths, so an elbow with 2 female ends would be ideal.

If someone knows of such an item on a pile of scrap somewhere or otherwise
recyclable that would be great.


Robin Gilks

More information about the Chchrobotics mailing list