<div dir="auto">I have been using L293DD. Up to 32V and 600mA, and seperate 4 channels in easy SMD package. <div><br></div><div>I have a few spare and a suitable PCB to drive 16 channels of LED lights if you want to experiment. It has a Pi Pico footprint on it but that isn't a big issue. </div><div><br></div><div>The PCB is useful as the need to sink a bit of heat into the PCB's ground plane. </div><div><br></div><div>Mike</div><div><div><div><div><div><br><br></div></div></div></div></div></div><div style="line-height:1.5"><br><br>-------- Original message --------<br>From: Mark Atherton <markaren1@xtra.co.nz><br>Date: Mon, 24 May 2021, 12:34 PM<br>To: Christchurch Robotics <chchrobotics@lists.linuxnut.co.nz><br>Subject: [chbot] 12V driver<br><blockquote>Andrew,<br><br>After all that I forgot...<br><br>ULN2003 - seven drivers in a 16 pin DIP, Jaycar ZK8855, $5.90 ea.<br><br>5V in, capable of switching 500mA at 50V. Built in back EMF diode (tie <br>pin 9 to the positive rail associated with the load).<br><br>-Mark<br><br><br><br>_______________________________________________<br>Chchrobotics mailing list Chchrobotics@lists.ourshack.com<br>https://lists.ourshack.com/mailman/listinfo/chchrobotics<br>Mail Archives: http://lists.ourshack.com/pipermail/chchrobotics/<br>Meetings usually 3rd Monday each month. See http://kiwibots.org for venue, directions and dates.<br>When replying, please edit your Subject line to reflect new subjects.</blockquote></div>