[chbot] PCB Power Supply.

[Daniel Powell]

To preface, I know nothing about PCB design, nor much of anything about components. 

I thought of using an off the shelf board for datalogging my race car. I've picked up a Kincony KC868-16 with the hopes of being able to float off the RS485 transceiver and replace it with a Canbus transceiver (Yeah, I'm going to screw this board!!)

My issue. While I know the board is 12v tolerant and the xl1509 should handle the voltages seen in car (12-15v) I don't know if the remainder of the components will do so. Anyone with more firing neurons than me able to look at the diagram/pic below and tell me how quickly I'm going to release the smoke?

https://www.kincony.com/images/user-guide/manual/KC868-A16-images/ch00-power.png


https://www.kincony.com/images/user-guide/manual/KC868-A16-images/sh-00-power.jpg


Regards, 
Daniel.