[chbot] [OT] plumbing parts for a Gemini Shower
jasper.mackenzie at gmail.com
Thu Jan 21 22:47:29 GMT 2021
I hate the shower mixer and hope that they cannot fix it and instead
replace it with a halfway decent one that lets you change.... temperature
AND pressure. WOW 8)
Then I can 3D print myself a WIN tick or something 8)
On Fri, 22 Jan 2021 at 10:31, Volker Kuhlmann <list57 at top.geek.nz> wrote:
> > Cut the PEX or PB pipe, shorten it slightly, then with the tap open
> slide it onto the pipe. Job done.
> The seal is pressing on the outside of the pipe, so whereever you cut
> your pipe, you need it to have no surface marks or other damage where it
> sits inside the fitting. I found it easier/safer to chamfer the pipe
> ends a bit and put some tap grease on before carefully pushing them into
> a similar coupling without dislodging the O-rings.
> After several uses of the roadside shutoff valve, I found it worked
> better each time it got turned off hard, and then turned on again. I
> figure that was dislodging deposits around the sealing surfaces.
> There'll be similar issues with anything new you install - valves that
> are open forever don't close properly when needed eventually.
> Try turning the shutoff off and on a few times and see if it makes it
> work properly again. Preferably do this before needing it in an
> emergency. That reminds me, ...
> Volker Kuhlmann
> http://volker.top.geek.nz/ Please do not CC list postings to me.
> Chchrobotics mailing list Chchrobotics at lists.ourshack.com
> Mail Archives: http://lists.ourshack.com/pipermail/chchrobotics/
> Meetings usually 3rd Monday each month. See http://kiwibots.org for
> venue, directions and dates.
> When replying, please edit your Subject line to reflect new subjects.
-------------- next part --------------
An HTML attachment was scrubbed...
More information about the Chchrobotics