[chbot] 7mm nuts

[Robin Gilks]

> Do you need pot-nuts (they used to be 3/8")
>
> any chance of a part number, or supplier etc.
>
> -mark

They are pot nuts but 3/8" is closer to 9.5mm (32tpi thread as I recall!!)
- these ones are made by Keyes (at least that is what it says on the PCB)
and according to the big 'G' they are 7mm and I've mic'ed them to 6.9mm
which sounds about right ;)

>
> At 04:10 p.m. 9/01/2015, you wrote:
>>Failed again...
>>
>>Just received some panel mount rotary encoders but no nuts or washers
>> have
>>been supplied. Anyone know where I can get half a dozen thin 7mm nuts?
>>(Blacks only have full nuts).
>>
>>Cheers
>>
>>--
>>Robin Gilks
>>Internet: robin at gilks.org    http://www.gilks.org
>>Tel:      (+64) (3) 347 4370
>>
>>
>>
>>_______________________________________________
>>Chchrobotics mailing list Chchrobotics at lists.linuxnut.co.nz
>>http://lists.ourshack.com/mailman/listinfo/chchrobotics
>>Mail Archives: http://lists.ourshack.com/pipermail/chchrobotics/
>>Meetings usually 3rd Monday each month. See http://kiwibots.org for
>>venue, directions and dates.
>>When replying, please edit your Subject line to reflect new subjects.
>
>


-- 
Robin Gilks
Internet: robin at gilks.org    http://www.gilks.org
Tel:      (+64) (3) 347 4370