[chbot] slightly OT: PCB fab places...

[Michael Pearce]

45c /sq cm is quite expensive for production... not bad for a prototype.

I used to pay NZ 40c / sq inch for small production runs of DSPTH with
solder Masks.

Mike


On Tue, Nov 9, 2010 at 2:13 AM, Mikael Stewart <mikael.stewart at gmail.com> wrote:
> I've been waiting for the chance to try out
> www.pcbzone.net/PCBZ/homepage.asp which is run by circuitlabs.co.nz. I
> think I remember seeing a cost of $0.45per sq cm on their flyer at work
> (I can fetch it and email you a copy if you like).  I've used
> circuitlabs for work before and was satisfied with the results, so
> PCBZONE is first on the list for my next hobby project. It looks like
> your requirements fit within theirs.
>
> Cheers,
> Mikael
>
>
>
> On 6/11/2010 10:54 p.m., Chris Hellyar wrote:
>> Hi-ho,
>>
>> What's current pick of the bunch for getting some low volume PCB's
>> made up?
>>
>> >From Gerber files out of kicad, single sided, no pth masked and
>> screened...
>>
>> Cheers, Chris H.
>>
>>
>> _______________________________________________
>> Chchrobotics mailing list Chchrobotics at lists.linuxnut.co.nz
>> http://lists.ourshack.com/mailman/listinfo/chchrobotics
>> Mail Archives: http://lists.ourshack.com/pipermail/chchrobotics/
>> Web site: http://kiwibots.org
>> Meetings 3rd Monday of each month 6.30pm Science Alive Seminar Room
>>
>> When replying, please edit your Subject line to reflect new content.
>
> _______________________________________________
> Chchrobotics mailing list Chchrobotics at lists.linuxnut.co.nz
> http://lists.ourshack.com/mailman/listinfo/chchrobotics
> Mail Archives: http://lists.ourshack.com/pipermail/chchrobotics/
> Web site: http://kiwibots.org
> Meetings 3rd Monday of each month 6.30pm Science Alive Seminar Room
>
> When replying, please edit your Subject line to reflect new content.
>