[chbot] PCB Manufacture

[Chris Hellyar]

It's been a while since I had any boards done, but I'm pretty sure that
Huntsbury will be cheaper for small runs wont they?  I did all my low
volume stuff through him for Ohmark, and their stuff was always good
quality, and at a pretty competitive price..

I might right tomorrow and check, I'll be in the market for some PCB's
in the next few weeks as well with my 'stampalike' project. :-).

As Andrew McDougal said, support the local guys..

On Tue, 2008-03-04 at 16:19 +1300, Richard Jones wrote:
> Hanno was asking about printed circuit board manufacture.
> I have just seen some PCBs made by these folks:
> http://pcetek.com/default.aspx
> They came highly recommended, easy to deal with, flexible, good product 
> and no errors.
> $150 first A4 panel, extra panels $50.
> Useable area 264x200 mm, PTH, standard finish - HASL, solder mask and 
> silk screen included.
> 
> Cheers
> 
> Richard Jones
> 
> 
> =======================================================================
> This email, including any attachments, is only for the intended
> addressee.  It is subject to copyright, is confidential and may be
> the subject of legal or other privilege, none of which is waived or
> lost by reason of this transmission.
> If the receiver is not the intended addressee, please accept our
> apologies, notify us by return, delete all copies and perform no
> other act on the email.
> Unfortunately, we cannot warrant that the email has not been
>  altered or corrupted during transmission.
> =======================================================================
> 
> 
> _______________________________________________
> Chchrobotics mailing list
> Chchrobotics at lists.linuxnut.co.nz
> http://lists.ourshack.com/mailman/listinfo/chchrobotics
>